Table of Contents
Advertisement
Z9264F-ON switch installation
To install the Z9264F-ON switch, complete the installation procedures in the order
presented in this section.
Always handle the switch and its components with care. Avoid dropping the switch or any
field replaceable units (FRUs).
NOTE:
ESD damage can occur if components are mishandled. Always wear an ESD-
preventive wrist or heel ground strap when handling the switch and its components.
As with all electrical devices of this type, take all the necessary safety precautions
to prevent injury when installing this switch.
Topics:
•
Unpack
•
Four-post rack assembly
•
Four-post rack mount
•
Ground cable
•
Optics installation
•
Switch power-up
•
After switch installation
Unpack
NOTE:
Before unpacking the switch, inspect the container and immediately report
any evidence of damage.
When unpacking the Z9264F-ON switch, make sure that the following items are included:
•
One Z9264F-ON switch
•
One RJ-45 to DB-9 female cable
10
Z9264F-ON switch installation
3
Advertisement
Table of Contents
