Introduction; Symbols Used In This Manual; Approvals; Copyright - Danfoss VLT OneGearDrive Instruction Manual

Introduction

1 Introduction

1.1 Symbols used in this Manual

The following symbols are used in this manual.
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices.
CAUTION
Indicates a situation that may result in equipment or
property damage-only accidents.
NOTICE!
Indicates highlighted information that should be given
extra attention to avoid mistakes or operating the
equipment at less than optimal performance.

1.2 Approvals

Table 1.1 Approvals

1.3 Copyright

Disclosure, duplication and sale of this document, as well
as communication of its content, are prohibited unless
explicitly permitted. Infringement of this prohibition incurs
liability for damages. All rights reserved with regard to
patents, utility patents, and registered designs.
OneGearDrive is a registered trademark.
®
VLT OneGearDrive Instruction Manual

1.4 Disclaimer

No liability is assumed for any damage or breakdown
resulting from:

1.5 Service and Support

Contact your local service representative for service and
support:
www.danfoss.com/Contact/Worldwide/

1.6 Purpose of this Instruction Manual

The purpose of this Instruction Manual is to describe the
VLT
information about:
NOTICE!
For reasons of clarity, the Instruction Manual and safety
information do not contain all information relating to all
geared motors types and cannot take into account every
conceivable case of installation, operation, or maintenance.
The information is limited to what is required for qualified
personnel in normal working situations. Any unclear points
can be clarified by contacting Danfoss.
This Instruction Manual is intended for use by qualified
personnel. Read this Instruction Manual in full in order to
use the VLT
®
MG75C322 - VLT is a registered Danfoss trademark
•
failure to observe the information in the
instruction manuals
•
unauthorized modifications to the VLT
OneGearDrive
•
operator error
•
improper work on or with the VLT
OneGearDrive.
®
OneGearDrive. This Instruction Manual contains
•
Safety
•
Installation
•
Commissioning
•
Maintenance and Repair
•
Specifications
•
Options and Accessories
®
OneGearDrive safely and professionally. Pay
1 1
®
®
1-1