Cage Clamp Connection Diagram - Danfoss VLT OneGearDrive Instruction Manual

Installation

2.10 Cage Clamp Connection Diagram

2 2
CAUTION
Refer to the Instruction Manual for VLT
terminals.
Do not connect the VLT
Figure 2.6 shows the VLT
protection.
Figure 2.6 Cage Clamp Connection Diagram
Description
Motor winding
Protective Ground
Temperature protection
KTY 84-130
Table 2.5 Cage Clamp Connections
1) When connected to VLT
information about parameter setting and programming, refer to the corresponding instruction manual.
2-6
®
VLT OneGearDrive Instruction Manual
®
AutomationDrive FC 302 and VLT
®
OneGearDrive directly to the power supply.
®
OneGearDrive DA09LA10 with terminal box in Y-connection and the connection to the thermal
V1
Inverter output
U
V
W
PE
1) T1
T2
®
AutomationDrive FC 302 and VLT
MG75C322 - VLT
®
Decentral Drive FCD 302 to connect the
W1
U1
U V W PE T1
U V W
Color Typical cross-section
black
AWG 16/1.5 mm
blue
brown
yellow/green
AWG 16/1.5 mm
white
AWG 20/0.75 mm
brown
®
Decentral Drive FCD 302, use analog input terminal 54, KTY sensor 1. For
®
is a registered Danfoss trademark
T2
Maximum cross-section
2 AWG 14/2.5 mm 2
2 AWG 14/2.5 mm 2
2 AWG 16/1.5 mm 2