Safety Information For The Operation Of Geared Motors; General; Transportation, Storage; Inspection On Receipt - Danfoss VLT OneGearDrive Instruction Manual

Introduction
1 1
particular attention to the safety instructions and general
warnings.
This Instruction Manual is an integral part of the VLT
OneGearDrive and also contains important service
information. Therefore keep this instruction manual
available with the VLT
Compliance with the information in the Instruction Manual
is a prerequisite for:
•
trouble-free operation
•
recognition of product liability claims
Therefore, read this Instruction Manual before working
®
with the VLT
1.7 Safety Information for the Operation of
Geared Motors

1.7.1 General

This safety information applies in addition to the relevant
product-specific Instruction Manual and for safety reasons
must be taken into particular consideration in every case.
This safety information is intended to protect persons and
objects from injury and hazards which can arise from
improper use, incorrect operation, inadequate
maintenance, or other incorrect handling of electric drive
units in industrial installations. Low-voltage machines have
rotating parts and may have parts that are live, even when
the machine is at rest, and surfaces that may become hot
in operation. Warning signs and information signs on the
machine must be observed without exception. Details can
be found in our detailed Instruction Manual. It is included
in the machine delivery and can be requested separately if
necessary by indicating the motor model.

1.7.2 Transportation, Storage

1.7.2.1 Inspection on Receipt

After receiving the delivery, immediately check whether
the scope of delivery matches the shipping documents.
Danfoss will not honor claims for defects registered later.
Register a complaint immediately:
•
with the carrier in the case of visible transport
damage
•
with the responsible Danfoss representative in
the case of visible defects or incomplete delivery
1-2
®
OneGearDrive at all times.
OneGearDrive.
MG75C322 - VLT
®
VLT OneGearDrive Instruction Manual
Commissioning may have to be suspended if the unit is
damaged.

1.7.2.2 Transport

®
Before transporting the VLT
provided must be firmly tightened down to its bearing
surface. The eye bolt can only be used to transport the
®
VLT OneGearDrive unit and not for lifting attached
machines.
If the VLT
dust free environment with a low vibration rating of v
0.2 mm/s.
Damage sustained during storage:
•
•
•

1.8 Qualified Personnel

All necessary work on electric drive units, in particular also
planning work, transport, assembly, installation, commis-
sioning, maintenance, repair, may only be performed by
adequately qualified personnel (e.g., electrical engineers as
specified in draft EN 50 110-1/DIN VDE 0105), who have
the Instruction Manual provided and other product
documentation available during any corresponding work
and who are obliged to abide by the instructions they
contain. This work must be monitored by a specialist
supervisor. Qualified personnel are persons who are
authorized due to their training, experience, and
instruction as well as their knowledge of relevant
standards, rules, accident prevention regulations, and
operating conditions. The person responsible for the safety
of the installation must perform the activities required in
each case and be able to recognize and avoid potential
hazards.
Knowledge of First Aid and of the necessary lifesaving
equipment available is also required.
Non-qualified personnel are forbidden to work on the VLT
OneGearDrive.
®
is a registered Danfoss trademark
®
OneGearDrive the eye bolt
®
OneGearDrive is to be stored, ensure a dry,
The life of the lubricants and seals is reduced
with longer storage times.
There is a risk of fracture at very low temper-
atures (under approximately -4° F [-20 °C])
If the transport eye bolts are replaced, use drop
forged eye bolts as specified in DIN 580.
<
eff
®