Three-Phase Gear Motors Connection Diagram - Danfoss VLT OneGearDrive Instruction Manual

Installation
T1
KTY 84-130
T2
Table 2.6 Connections T1 and T2
1) Only if connected

2.11 Three-phase Gear Motors Connection Diagram

CAUTION
Refer to the Instruction Manual for VLT
terminals.
®
Do not connect the VLT OneGearDrive directly to the power supply.
Figure 2.7 shows the connection power plug for VLT
Figure 2.7 Three-phase Gear Motor Connections
Description
Motor winding
Protective Ground
1)
Temperature protection
KTY 84-130
Table 2.7 Three-phase Gear Motor Connections
®
1) When connected to VLT AutomationDrive FC 302 and VLT
information about parameter setting and programming, refer to the corresponding instruction manual.
T1
KTY 84-130
T2
Table 2.8 Connections T1 and T2
1) Only if connected
®
VLT OneGearDrive Instruction Manual
®
1)
VLT AutomationDrive FC 302
®
AutomationDrive FC 302 and VLT
®
OneGearDrive Hygienic DA09LA10 in Y-connection with thermistors.
V1 W1
U1
Inverter output Pin
U 1
V 3
W 4
PE 2
T1 A
T2 B
®
Decentral Drive FCD 302, use analog input terminal 54, KTY sensor 1. For
®
1)
VLT AutomationDrive FC 302
®
MG75C322 - VLT is a registered Danfoss trademark
®
VLT Decentral Drive FCD 302
KTY Sensor 1
Analog Input 54
®
Decentral Drive FCD 302 to connect the
V
D
W 3
C
4
2
B T1
1 A
T2
U
Typical cross-section Maximum cross-section
2
AWG 16/1.5 mm AWG 14/2.5 mm
AWG 16/1.5 mm 2 AWG 14/2.5 mm
AWG 20/0.75 mm 2 AWG 16/1.5 mm
®
VLT Decentral Drive FCD 302
KTY Sensor 1
Analog Input 54
1)
2
2
2
2
1)
2-7
2