Assembly Instructions - Deprag AST11-1 Operating Instruction Booklet

7.2 Assembly Instructions

WARNING
Risk of fatal injury due to electrocution!
Switch off the AST11 sequence controller at the main switch and remove
the mains plug before connecting the screwdriver!
Commissioning should be done only by trained personnel.
For the initial start-up proceed as indicated in the brief instructions 014090 "Quick-Start
Instructions for the Operation of the Sequence Controller AST11 with 320E... EC-
screwdriver"
CAUTION
Injuries from electricity or damages on the device
Prior to connecting to the power, compare the layout design of the sequence
controller AST11 with the in-house power supply (also refer to
Data)
Connect the EC-screwdriver (to the GX1 inter-
face) and screw on the retaining screw tightly.
Optional:
Connect the screw feeder / start release signal,
if there is a screw feeder.
(Interface GX8)
Optional:
Connect the F-control, if there is an F-control.
(Interface GX7)
19
18 Technical