Settings; Description Of The Adjustable Parameters; Parameters Of The System Settings - Deprag AST11-1 Operating Instruction Booklet

10 Settings

10.1 Description of the adjustable parameters

10.1.1 Parameters of the System Settings

Parameter
IP Address
Network mask
Gateway
Display contrast
Language
Torque unit
Main direction of rotation
Speed reduction
Start release
Beeper
Print options
Torque adjustment
Description
The IP address via which the AST11 can be reached
in the network.
It indicates the network segment in which the se-
quence controller AST11 is located.
The IP address of the gateway for the network seg-
ment in which the sequence controller AST11 is lo-
cated.
The display contrast can only be set on the sequence
controller.
The language that should be displayed in the web
interface as well as also the operating interface of the
sequence controller AST11.
The torque unit that is used for display and settings of
torque values.
Available units are:
• N·m
• N·cm
• ft·lb.
• in·lb.
• kg·m
• kg·cm
The main direction of rotation indicates what direction
is defined as screwing application. The main direction
right means that all screwing samples will operate
rotating to the right, all screw samples to release with
rotate to the left.
If the rotation speed decrease is active then the
torque screwing levels, that do not have torque trans-
fer occurring, will automatically lower the rotation
speeds when 80% of the target torque is reached.
This provides a higher cut-out accuracy.
If the clearance to start is active then a screwing ap-
plication can only be started, if 24 V are available at
the start release input (also refer to
face). Otherwise the controller will not be ready for a
screwdriving cycle.
Determines under which conditions the signal sound
is released at the end of the screwing process.
Determines what should be printed if a program uses
the command "Print" and a printer is connected to the
serial interface.
Adjustment factor for the torque calculation for special
screw joints
74
6.2.5 I/O Inter-