Deprag AST11-1 Operating Instruction Booklet page 41

8.2.5.3.2 Language
The system allows the selection between different languages.
Use the cursor keys to select the required language and confirm your selection with the
ENTER-key. To leave the menu without making any changes, use the ESC-key.
8.2.5.3.3 Unit
Several different measuring units are available.
Use the function keys for selection and the ENTER key to accept the selection. Use the
ESC-key to exit the menu without making any changes.
8.2.5.3.4 Main Direction
Use this area and the cursor keys to select between "Right" or "Left" main direction. The
basic setting is RIGHT. Use the ENTER key to accept the selection. Use the ESC-key to
exit the menu without making any changes.
8.2.5.3.5 Startmode Handtool
It can be selected to use external start (start and program choice by e.g. PLC) with the
handtool.
8.2.5.3.6 Optional Parameters
8.2.5.3.6.1 Password
The password can be changed using the left cursor key or even deleted, using the right
cursor key.
ATTENTION
If a password is deleted, then all menus are freely available!
The following menus interrupt the automatic cycle:
• Setup
• Screwdriving Sequence
• Test
Please assure by setting passwords that only authorized personnel can
make changes to the corresponding menus.
To change the password, input a four-digit password and confirm entry with the ENTER-
key. It is necessary to input the password twice and if both entries are identical, then the
password will be accepted. The password may be any combination of digits between 0000
and 9999.
41