System Info  System Data; Figure 17: System Data - Deprag AST11-1 Operating Instruction Booklet

System Info  System Data
8.3.4.3
This page shows the screwdriver independent adjustments of the sequence controller.
These data cannot be changed on this page.
Figure 17: System data
The following data is displayed:
• Version of main unit: software version of the main unit
• Version of power unit: software version of the power unit
• Date: the date set in the sequence controller
• Time: the time set in the sequence controller
• IP-Address: IP address of the sequence controller
• Netmask: bitmask of the sequence controller network element
• Gateway: IP address of the gateway set in the sequence controller
• MAC Address: hardware address of the Ethernet port
• Torque unit: the set torque unit
• Main direction of rotation: set direction of rotation for a standard screwdriving applica-
tion
• Speed reduction: automatic decrease of the speed at 80% of the target torque
• Start release: control of the 'Ready'-state by a higher level controller
• Beeper: Setting for the signal sound at the end of the screwdriving application
o always
o only O.K.
o only NOT O.K.
o never
54