Special Parameters For Fieldbus Systems (Optional); Profibus; Profinet; Ethernet Ip - Deprag AST11-1 Operating Instruction Booklet

F-Control active
Reset by Button
Release by Button
Number of Cycles
Minimum Time
Maximum Time
Table 17: Adjustable parameters

10.1.2 Special parameters for fieldbus systems (optional)

10.1.2.1

Profibus

Parameter
Profibus address

Table 18: Configurable Profibus parameters

10.1.2.2

Profinet

Parameter
IP address
Net mask
Gateway
Station name

Table 19: Configurable Profinet parameters

10.1.2.3

Ethernet IP

Parameter
IP address
Net mask
Gateway
DHCP
BOOTP

Table 20: Configurable Ethernet IP parameters

10.1.2.4

Ethercat

No settings are necessary.
Indicates whether F-control is active.
If there is an error in screw assembly the reset button
can be pressed.
Once screw assembly on a part is finished this button
releases the part.
Number of screw assemblies per component
Minimum screw assembly time
Maximum screw assembly time
Description
Address under which the AST11 is accessible in the
Profibus.
Description
The IP address via which the AST11 is accessible in
the network via Profinet.
It designates the network segment in which the
AST11 sequence controller lies.
The IP address of the gateway for the network seg-
ment in which the AST11 sequence controller lies.
Station name of the AST11 in the Profinet.
Description
The IP address via which the AST11 is accessible in
the network via Ethernet IP.
It designates the network segment in which the
AST11 sequence controller lies.
The IP address of the gateway for the network seg-
ment in which the AST11 sequence controller lies.
If DHCP is active, the network addresses set / dis-
played are not valid. They are assigned via a DHCP
server.
If BOOTP is active, the network addresses set / dis-
played are not valid. They are assigned via BOOTP.
76