Assembly - Deprag AST40-1 Operating Instruction Booklet

7.2

Assembly

WARNING
Risk of fatal injury due to electrocution!
Switch off the AST6 sequence controller at the main switch and
disconnect the power plug before connecting the screwdriver!
Commissioning may only be performed by qualified personnel.
CAREFUL
Injuries due to electricity and/or damage to the device
Before connecting to the electrical supply, compare the rating of the
AST40's sequence control system with the building's internal power
supply (also see 20 Technical
Plug in the EC-Servo screwdriver using the
motor cable (interface GX1) and fasten the
connector with a quarter rotation to the right.
Plug in the connector for the I/O interface SPS1
(interface GX2) and firmly tighten the retaining
screws.
Connect the emergency stop cable (interface
GX9).
Connect the voltage supply cable (interface
GX8) and fasten the cable using the silver
colored bracket.
Silver colored
bracket
Data)
19