Procedures For Single Sitepro; Initial Start-Up Of The Sitepro - GE 8 Series Operating Manual

8.1

PROCEDURES FOR SINGLE SitePro

8.1.1 Initial start-up of the SitePro

WARNING !
Before proceeding to turn on the UPS system, ensure that the AC and DC external
isolators are OFF, and prevent their inadverted operation.
Ensure that the output load distribution can be powered and all the output isolators
are open.
Open the front door and make sure that:
All the connections to the input/output terminals of the UPS have been made correctly.
•
The safety screens are fixed in their position.
•
The switches Q1, Q2 and Q4 are open (Pos. O) and the battery fuses F8 – F9 are disconnected.
•
SP_010-040_S6_Q1 Q2 Q4_01
I I
Q1 Q2
ON ON
O O
OFF OFF
Q1 Output UPS switch
Q2 Manual bypass switch
Q4 Input rectifier switch
Battery fuses F8 – F9
1. Switch-ON the mains voltage from the input distribution (both rectifier and bypass if separated).
At this stage the electronic power supply is switched ON and the buzzer sounds.
LED 2 (input mains bypass) must be ON.
Press "MUTE" key to reset acoustical alarm.
LED Alarm remains lit.
The UPS performs a SELFTEST.
A successful termination of the tests will be indicated with Overall
test results "OK".
Commissioning cannot be continued should one or more tests result
to be negative.
Please contact in this case your Service Centre.
Modifications reserved
OPM_SPE_XXX_10K_40K_8GB_V020.doc
Q4 I
ON
O
OFF
LED 1
LED 2
LED 3
LED 4a
LED 4b
LED 5
Key
Inverter ON Inverter OFF
LEDs on synoptic diagram
Input mains rectifier
Input mains bypass
Rectifier ON
Discharging battery
Charging battery
Inverter ON
Key Key
Load Off Stop Operation
LED 6 Load on inverter
LED 7 Q1 closed
LED 8 Load on automatic bypass
LED 9 Manual bypass Q2 ON
LED 10 Load on UPS
LED LED
Alarm
Overall test results
Test1 OK Test7 OK
Test2 OK Test8 OK
Test3 OK Test9 OK
Test4 OK Test10 OK
Test5 OK Test11 OK
Test6 OK
Operating Manual SitePro 10-15-20-30-40 kVA / S8
LED
Operation
►
Continue
Page 63/99