FujiFilm SonoSite EDGE II Service Manual page 54

Figure 6.2 Control Panel Screw
3 Remove the screw securing the Control Panel to the midframe as shown in
4 Remove the eight screws from the Bottom Enclosure of the system with a #2 Phillips screw driver per
Figure 6.3.
Figure 6.3 System Bottom
5 After removing the Bottom Enclosure, remove the two screws and flex cable indicated in
Note: the fan assembly next to the TGC blocks access to the screw on the right side so it must be
removed. To do this, remove the two screws securing the TGC which will allow it to pop up. This will
provide enough room for the fan assembly removal.
46 Chapter 6: Replacement Procedures
Figure 6.2.
Screws (8x)
Note: the two screws
marked in red are longer
and need to be placed
in the same location when
reassembled
Figure 6.4.