FujiFilm SonoSite EDGE II Service Manual page 62

Power Supply PCBA Replacement
Required Part
• P08850-XX Service Assembly, Power Supply, M-Turbo (Compatible with the SonoSite Edge II system)
• V08850-XX Vet Service Assembly, Power Supply, M-Turbo
Power Supply Removal
1 Remove the 7 long screws and 2 short screws holding the Power Supply Shield lid. Please note the
location of the 2 short screws. See
Note: Early systems will have a piece of kapton tape over the bottom left screw hole with no screw
present. Later systems will have a spring screw installed in this location. The spring screw prevents the
shield from flexing and possibly damaging components on the Main PCBA near that corner and can
reduce the likelihood of assert codes due to this damage. If the Main PCBA is replaced, the Service
Assembly will come with the spring screw for installation on older systems mentioned above. There is no
need to proactively install this screw.
Long Screws (7x)
Short Screws (2x)
Kapton
tape/spring
screw location
Figure 6.12 Power Supply Shield
2 Gently lift the Power Supply PCBA and Power Supply Shield away from the Main PCBA as shown in
Figure 6.13. (The Power Supply PCBA connector is in the upper left corner. Removing the Power
Supply PCBA without also removing the shield is difficult.)
3 Once disconnected from the Main PCBA, separate the Power Supply PCBA from the Power Supply
shield.
4 Install the new Power Supply PCBA by reversing steps 1-2 and tighten all screws to 5.5 inch lbs.
54 Chapter 6: Replacement Procedures
Figure 6.12. Remove lid and set aside.
Power Supply
shield