FujiFilm SonoSite EDGE II Service Manual page 56

Figure 6.6 Control Panel Removal
8 Remove the J5 "LCD IN", J6 "LCD OUT" and J7 "BL IN" cables by gently pulling away from their sockets.
9 Remove the J4 "SPI" ribbon cable after unlocking the dark gray retainer on the socket as shown in
Figure 6.7. The control panel can now be removed..
Figure 6.7 Control Panel Bottom
10 Tilt the system back onto the top cover allowing the LCD to lie on its back.
11 Remove the 4 screws from the LCD display hinges as shown in
48 Chapter 6: Replacement Procedures
J5
J6
Caution:
J4 requires the gray lock tab to be
lifted at the end closest to the
ribbon cable. Use care as the lock
tab hinge points are fragile.
J4
J7
J4
Figure 6.8 and remove the display LCD.