Diagnostics - SAMES KREMLIN Cyclomix Micro User Manual



DIAGNOSTICS

ELECTRIC
TM
The CYCLOMIX MICRO does not switch on
You can choose the color (when using a 3 colors'
TM
CYCLOMIX MICRO)
FLUID
No fluid flows when passing into production or
flushing mode.
In production : there is only catalyst and the
injection valve opens but does not close.
Moreover, the CYCLOMIX
indicate faults.
In production : the base only flows and the
injection valve does not open.
TM
The CYCLOMIX
mixing but the consumption of catalyst is too
important.
TM
The CYCLOMIX
mixing but the consumption of catalyst is not
enough.
When the main menu page is displayed, fluid
flows out when the gun is open
In production : the fluid flows from the TA test
outlet
SAMES KREMLIN
FAULTS
FAULTS
TM
MICRO does not
MICRO displays the correct
MICRO displays the correct
Page 34
CHECKING
Check that the isolating switch is on 'I'.
Check that the mains supply is connected.
No : connect it.
Check that the fuse on the electric card inside the
box is in working order.
No : change the fuse (ind. 3).
Check the electric wiring of the supply cable (bad
contact or other).
Check the connection of the J7 shunt inside of the
electric box (refer to Annexes).
CHECKING
Check if the valves are open :
No : - Check air supply (minimum 4 bar / 58 psi),
- Check the connection of the 25 pts cable
- Check the correct operating of
theelectrovalves.
Yes : - Check the fluid pressure
- Check the static mixer.
Check the flow switch and the CATALYST flowmeter.
Check the flow switch & the BASE flowmeter.
Check the non-return valve of the BASE .
Check the grounds of the CYCLOMIX
(230V intake and ground cable of the fluid module)
Check the grounds of the CYCLOMIX
Check the valves
Checking of the valve : look at what is flowing :
if it is solvent, change the valve (Vp 1),
if it is base, change the valve (Vp 2),
if it is catalyst, change the valve (Vp 6).
Change the 3 way-valve.
TM
MICRO
TM
MICRO.
Manual : 573.191.112