Maintenance Requirements; Environment - SAMES KREMLIN Cyclomix Micro User Manual

GUN
Never wipe the end of the tip with the fingers.
Always depressurize air and fluid hoses before carrying out any servicing on the gun.
Never point the spray gun at anyone or at any part of the body.
TM
CYCLOMIX MICRO

Do not install the CYCLOMIX
explosive area).

The display control unit must not be installed above the fluid module.

Connect the display control unit to the mains supply fitted with a ground.

The fluid module is fitted with a ground. Connect the ground cable to earth.

Do not use any product or solvent incompatible with the components of the CYCLOMIX
MICRO.

Use the appropriate solvent for the material being sprayed to increase the equipment
working life.

Wear protective glasses to protect the operator from possible discharges during the
handling of the CYCLOMIX

Do not use electrostatic spraying for water-based paints with a resistivity lower than 5 MΩ.


MAINTENANCE REQUIREMENTS

Guards (air motor cover, coupling shields, connectors,...) have been designed for
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards.

Never modify these equipments.
Check them daily, keep them in a good condition and replace the worn parts only with SAMES
KREMLIN parts.
Before cleaning or removing components of the equipment, it is compulsory :
1 - to stop the air supply,
2 - to open the gun fluid circuit to depressurize the hoses,
3 - to shut off the CYCLOMIX
4 - to open the drain valves.


ENVIRONMENT

SAMES KREMLIN
TM
MICRO in an explosive area. It shall be in a safe area (non
TM
MICRO test valves.
safe use of the equipment.
TM
MICRO electrical supply,
The equipment consists of a label plate with the name of the manufacturer, the
equipment part number, the interesting informations to use correctly the
equipment (pressure, voltage...) and the above pictogram.
The equipment is designed with and consists of high quality materials and
components which can be re-used.
The 2012/19/UE European Directive covers all equipments with a crossed-out
bin pictogram. Please inform yourself about the collection systems for electric
and electronic equipments.
Please act according to local rules and do not throw the old equipments with
household wastes. A correct disposal of the old equipment will help prevent
negative consequences for the environment and health.
Page 4
TM
Manual : 573.191.112