Otto Bock Motus CV Instructions For Use Manual page 62

Adjustment/Assembly instructions
Setting the rear wheel camber to 2.5°: Position the camber washer on the outside of the rear
wheel adapter with the thinner side pointing upwards and into the desired engaging position .
Setting the rear wheel camber to 0°: Remove the camber washer from the outside of the rear
wheel adapter and place it against the washer on the inside of the adapter such that the thinner
side of the washers is next to the thicker side of the other washer .
Further proceeding: Once you have applied the retaining washer from the inside , slightly tighten
the nuts on the rear wheel fitting. Check the space between the rear wheel and the side panel.
You can adjust the space by rotating the fitting.
Toe-in correction: For toe-in correction, the nuts on the rear wheel fitting remain loosened. Then
also loosen the oval head screw on the set plate . Then firmly retighten all screw connections.
Make sure to firmly retighten all screws and nuts after making adjustments. Observe
INFORMATION
the values indicated in chapter 6.1.
B
62 | Ottobock
A
38
40
A
B
39
Motus CV/CS