Connecting the Programming Console
1, 2, 3...
80
1. Remove the rear-upper cover or rear connector cover of the Programming
Console. Be careful not to misplace the removed cover.
2. Connect the square connector to the Programming Console. Press in the
square connector securely until the lock lever clicks.
3. Open the front cover of the Controller.
4. There is an arrow mark on the round connector. Make sure that the arrow
mark is faced upwards when connecting the round connector to the Pro-
gramming Console port on the Controller. Press the round connector se-
curely. This connector has no lock mechanism.
Do not touch the wires connected to the Controller when connecting or
disconnecting the connector while the Programming Console is ON, otherwise an
electric shock may be received.
CAUTION
!
Section
6-4