Controller
1, 2, 3...
38
• Use the provided ferrite core for the suppression of noise generation as shown
below.
1. Wire the power supply and ground wires.
2. Wind the power supply and ground wires together around the ferrite core
once so that the ferrite core will not move as shown below. The ferrite core
must be located within 10 cm of the Controller.
3. Close and press the ferrite core until the ferrite core clicks so that the ferrite
core will be locked.
4. If the synchronous cable is used, wind only the power supply wires around
the ferrite core as shown below.
24 VDC
Section
Ferrite core
Ferrite core
4-1