Omron V700 Series Operation Manual page 8

1. FCC Rules (Federal Communications Commission)
This Product complies with Part 15 Subpart C of the FCC Rules.
FCC ID: E4E6CYCIDV7000198
FCC NOTICE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Properly shielded ground cables and connectors must be used for connection to host computer and/or
peripherals in order to meet FCC emission limits.
Ferrite cores (TDK Type ZCAT2032-0930 or its equivalent) must be attached to the cables connecting the
power supply and ground to suppress RF interference.
Do not remove the ferite core (TDK Type ZCAT2035-0930A-BE), that is attached to the Antenna Cable.
2. EC Declaration of Conformity
Hereby, OMRON Corporation declares that this RFID System V700-H01 is in compliance with essential
requirements and other relevant provisions of Directive 1995/5/EC, and satisfy tests for the appropriate
requirements of the following relevant standards.
Radio: EN 300 330-2: 2001-06
EMC: EN 301 489-1: 2002-08
Safety: EN 61010-1: 2001
Countries of intended use:
Austria, Belgium, Denmark, France, Germany, Italy, Netherlands, Norway, Spain, Sweden, Switzerland, U.K.
!
CE
0891
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Properly shielded ground cables and connectors must be used for connection to host computer and/or
peripherals in order to meet the FCC emission limits.
 OMRON, 1998
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any
form, or by any means, mechanical, electronic, photocopying, recording, or otherwise, without the prior written permis-
sion of OMRON.
No patent liability is assumed with respect to the use of the information contained herein. Moreover, because OMRON is
constantly striving to improve its high-quality products, the information contained in this manual is subject to change
without notice. Every precaution has been taken in the preparation of this manual. Nevertheless, OMRON assumes no
responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the informa-
tion contained in this publication.
Standard Conformity
ix