Controller
Assembly of Connector
1, 2, 3...
42
1. Process the end of the cable as shown below.
Braided shield
• Insert the cable into the cable bushing.
• Untangle the braided shield for approximately 10 mm and fold it back on
the cable bushing.
• Apply shield tape to the untangled braided shield.
2. Solder the conductors to the plug pins.
Pin number
Shield
5
3
2
7 (see note)
8 (see note)
Note Short-circuit pins 7 (RS) and 8 (CS) with a jumper.
3. Attach housing A2 of the Hood to the Plug and secure the aluminum-taped
portion with the cable clamp and two screws.
4. Put on housing B2 to complete the connector assembly.
Conductors
Shield tape
Plug
Jumper
Aluminum tape
Symbol
GR
SG
SD
RD
RS
CS
Two, M2.6 lock screw
Housing A2
Cable clamp
Section
Cable bushing
Cable bushing
Name
Ground
Signal ground
Send data
Receive data
Request send
Clear to send
Housing B2
4-1