Omron V700 Series Operation Manual page 102

Functions
Read Retry
Write
After the data is read from the ID Tag, by pressing the SET Key again, the data
between the present start address and end address is read gain. By pressing the
INC or DEC Key, the start address and end address increase or decrease by 1
each and the corresponding data is read.
Data is written to the desired address of the ID Tag. The same data is written to all
the addresses in the designated area.
Set the start address to 10h and the end
address to 1Fh.
By pressing the SET Key, the data is read from
the ID Tag, and the data is displayed in a
maximum of four bytes beginning with the start
address.
By pressing the Right Key, the start address
increases by 1 and the corresponding data is
displayed in a maximum of four bytes beginning
with the new start address.
By pressing the SET Key, the data is read from
the ID Tag again.
By pressing the INC Key, the start address and
end address increases by 1 each and the
corresponding data is read from the ID Tag.
By pressing the DEC Key, the start address and
end address decrease by 1 each and the
corresponding data is read from the ID Tag.
Set the start address to 10h, the end address
to 1Fh, and set the data to 7F.
By pressing the SET Key, the data is written to
the ID Tag. "OK" will be displayed if the data is
written normally.
Section 6-6
89