Cisco ASR 9000 Series Service Configuration Manual page 117

Configuring Access Node Control Protocol on Cisco ASR 9000 Series Routers
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)#
Step 2
ancp rate-adjustment dsl-type
access-loop-type percent-factor factor
Example:
RP/0/RSP0/CPU0:router(config)# ancp
rate-adjustment adsl2 ethernet
percent-factor 90
OL-23108-02
configure
ancp rate-adjustment dsl-type access-loop-type percent-factor factor
end
or
commit
show ancp summary detail
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
How to Configure ANCP on Cisco ASR 9000 Series Routers
Purpose
Enters global configuration mode.
Sets the parameters for the ANCP shaper percent
factor. dsl-type and access-loop-type are compared
to appropriate values in optional type-length
values (TLVs) in the ANCP Port Up message and
the ANCP rate is adjusted by a configured factor in
case of a match.
dsl-type—(Required) Sets DSL type code:
•
adsl1
adsl2
adsl2+
vdsl1
vdsl2
sdsl
• access-loop-type—(Required) Sets
access-loop-type to ATM or Ethernet.
percent-factor factor—(Required) A percent
•
value to be applied to the ANCP reported rate
update prior to configuring it as a shaping rate.
QC-103