Configuring Nat Thresholds; Enabling Thresholds; Configuring Threshold Poll Interval; Configuring Thresholds Limits - Cisco ASR 5000 Series Thresholding Configuration Manual

▀ Configuring NAT Thresholds

Configuring NAT Thresholds
This section describes how to enable and configure NAT thresholds.

Enabling Thresholds

To enable thresholds use the following configuration:
configure
threshold monitoring firewall
context <context_name>
threshold monitoring available-ip-pool-group
end
Notes:
The
threshold monitoring available-ip-pool-group
pool thresholds. It is not required if you are only configuring NAT port-chunks usage threshold or many-to-one NAT.

Configuring Threshold Poll Interval

To configure threshold poll interval use the following configuration:
configure
threshold poll ip-pool-used interval <interval>
threshold poll nat-port-chunks-usage interval <interval>
end
Notes:
The
threshold poll nat-port-chunks-usage interval

Configuring Thresholds Limits

To configure threshold limits use the following configuration:
configure
context <context_name>
threshold ip-pool-free <high_thresh> [ clear <low_thresh> ]
ip-pool-hold <high_thresh> [ clear <low_thresh> ]
▄ Cisco ASR 5000 Series Thresholding Configuration Guide
92
Network Address Translation Thresholds
command is required only if you are configuring IP
command is only applicable to many-to-one NAT.
OL-25552-02