Replacing The Cutting Blade - Stihl ASA 85 Instruction Manual

19 Repairing
9
9
► Take out the screws (9).
► Remove and discard the anvil blade (8).
► Fit the new anvil blade (9) in position.
► Insert the screws (9) and tighten them down to a torque of
7 Nm.
5
6
8
► Lubricate bearing point of the cutting blade (6) and the
grease nipple (5) with STIHL multipurpose grease.
► Fit grease nipple (5) in the cutting blade (6).
► Fit cutting blade (6) on the anvil blade (8).
► Fit adjusting nut (7) on thread of grease nipple (5).
► Open the cutting blade (6).
► Engage the locking segment (3) on the adjusting nut (7),
insert the screw (4) and tighten it down to a torque of 7
Nm.
0458-285-9721-C
8
7 6
8 3 4
1
► Lubricate bores for pivot pin (1) with STIHL multipurpose
grease.
► If an ASA85/B blade assembly is fitted: Fit the spacer (2).
► Fit the pivot pin (1).
► Fit the E-clip (3).
► Lubricate cutting and anvil blades with grease gun.
► Adjust play between cutting and anvil blades.

19.4 Replacing the Cutting Blade

► Switch off the pruning shears and pull out the connecting
cable plug.
1
3
2
► Remove and discard the E-clip (3).
► Push out the pivot pin (1).
► If the pivot pin (1) is worn or damaged: Replace the pivot
pin (1).
English
2
3
4
5
25