Stihl MM 56 Instruction Manual
  1. Manuals
  2. Brands
  3. Stihl Manuals
  4. Power Tool
  5. MM 56
  6. Instruction manual

Stihl MM 56 Instruction Manual

Multisystem
Hide thumbs Also See for MM 56:
Table of Contents

Advertisement

Quick Links

STIHL MM 56
Instruction Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MM 56 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Stihl MM 56

Summary of Contents for Stihl MM 56

  • Page 1 STIHL MM 56 Instruction Manual...

  • Page 3: Table Of Contents

    Minimize Wear and Avoid Damage Main Parts Specifications Maintenance and Repairs Disposal EC Declaration of Conformity This instruction manual is protected by copyright. All rights reserved, especially the rights to reproduce, translate and process with electronic systems. MM 56 C...

  • Page 4: Multisystem

    Caution where there is a risk of damaging the machine or its individual Observe all applicable local safety In the STIHL MultiSystem a number of components. regulations, standards and ordinances. different MultiEngines and MultiTools can be combined to produce a power...
  • Page 5 The power tool can turn over or move Only use MultiTools and accessories while being transported. This may result that are explicitly approved for this in personal injuries and damage to power tool by STIHL or are technically property. Secure the power tool with MM 56 C...
  • Page 6 Never attempt to modify the controls – or the safety devices in any way. If you use metal tools, position the gearbox so that the axle is below the drive shaft. MM 56 C...
  • Page 7 MM 56 C...
  • Page 8 Check and correct the idle To reduce the risk of accidents, stop in particular for leaks and make sure the speed setting regularly. STIHL work immediately in the event of safety devices are working properly. Do recommends an authorized STIHL...

  • Page 9: Approved Multitools

    Maintenance and Repairs regular intervals. Use only a spark plug of the type Service the machine regularly. Do not approved by STIHL and make sure it is BF-MM RL-MM attempt any maintenance or repair work in good condition – see "Specifications".

  • Page 10: Adjusting The Bicycle Handle

    Engine Oil gasoline vapor. If you mix the fuel yourself, use only STIHL two-stroke engine oil or another STIHL MotoMix Loosen the knob (1). high-performance engine oil in accordance with JASO FB, JASO FC,...

  • Page 11: Fueling

    30 days. Exposure to light, the sun, low or high temperatures can quickly make the fuel mix unusable. STIHL MotoMix may be stored for up to 2 years without any problems. Thoroughly shake the mixture in the canister before fueling your machine.

  • Page 12: Starting / Stopping The Engine

    The stop switch returns automatically to the Run position when it is released: The ignition is switched on again after the engine stops – the engine is then ready to start. MM 56 C...
  • Page 13 The MultiTool must not rotate hand. when the engine is idling. Your machine is now ready for Version without ErgoStart operation. Pull the starter grip slowly until you feel it engage and then give it a brisk strong pull. MM 56 C...

  • Page 14: Extra Weight

    MultiEngine to fuel. increase the weight on the MultiTool. Set the choke knob to suit the Use only original STIHL weights. The engine temperature. use of other weights parts may result in Now start the engine.

  • Page 15: Wheels

    English STIHL recommends that you have Insert the bolt (2) with the Wheels servicing and repair work carried out washer (3) through the hole (4) in exclusively by an authorized STIHL the flange servicing dealer. For convenient transport, the Fit the washer (3) and tighten it...

  • Page 16: Operating Instructions

    Insert the screws (2) and tighten well away from sources of ignition, until them down firmly. you need it again. For longer out-of- service periods – see "Storing the Machine". MM 56 C...

  • Page 17: Adjusting The Carburetor

    Wait for the muffler to cool down. operating hours – or sooner if the electrodes are badly eroded. Install only suppressed spark plugs of the type approved by STIHL – see "Specifications". The carburetor has been set at the factory to provide an optimum fuel-air...

  • Page 18: Engine Running Behavior

    Have the muffler checked for Press the boot firmly onto the spark contamination (carbonization) by your plug. servicing dealer. STIHL recommends that you have Clean dirty spark plug. servicing and repair work carried out exclusively by an authorized STIHL Check electrode gap (A) and servicing dealer.

  • Page 19: Storing The Machine

    Remove, clean and inspect the Fold the handle down and hang up the attachment. machine by the handle support. Store the machine in a dry and secure location Keep out of the reach of children and other unauthorized persons. MM 56 C...

  • Page 20: Maintenance And Care

    Replace after every 100 operating hours Visual inspection Cooling inlet Clean Check Spark arrestor in muffler Clean or replace All accessible screws and nuts (not adjust- Retighten ing screws) Safety labels Replace STIHL recommends an authorized STIHL servicing dealer. MM 56 C...

  • Page 21: Minimize Wear And Avoid Damage

    English servicing dealer. STIHL dealers are Minimize Wear and Avoid regularly given the opportunity to attend Damage training courses and are supplied with the necessary technical information. Observing the instructions in this manual helps reduce the risk of unnecessary If these maintenance operations are not wear and damage to the power tool.

  • Page 22: Main Parts

    12 Knob 13 Loop handle 14 Carrying handle 15 Deflector 16 Gearbox 17 Axle 18 Hitch pin 19 Fuel tank 20 Tank cap 21 Manual fuel pump 22 Starter grip 23 Muffler with spark arresting screen Serial Number MM 56 C...

  • Page 23: Specifications

    1:1. Sound power level L Sound pressure level L to ISO 11789 EN ISO 118061 Weight 91 dB(A) 102 dB(A) Sound power level L to ISO 11789 Dry, without attachment 7.9 kg 100 dB(A) MM 56 C...

  • Page 24: Maintenance And Repairs

    When repairing the machine, only use replacement parts which have been The applicable exhaust emission Sound power level L to EN 13684 approved by STIHL for this power tool or requirements are fulfilled by the are technically identical. Only use high- MF-MM: 101 dB(A)

  • Page 25: Disposal

    MM 56 Serial identification: 4604 Displacement: 27.2 cc STIHL products must not be thrown in the garbage can. Take the product, conforms to the relevant provisions of accessories and packaging to an Directives 2011/65/EU, 2006/42/EC und approved disposal site for environment- 2014/30/EU and has been developed friendly recycling.
  • Page 26 English MM 56 C...
  • Page 28 0458-489-8321-A www.stihl.com *04584898321A* 0458-489-8321-A...

This manual is also suitable for:

Yard boss mm 56 c-eMm 56 multiengine46040115401

Table of Contents

Save PDF