Table of Contents
Advertisement
www.ti.com
The DLP LightCrafter Display board contains the RGB LED connectors, the Flex cable connector, and the
system board connector. To connect the system board to the DLP LightCrafter Display board, refer to
Figure
8-2. Note that the system board connector on the DLP LightCrafter Display board is on the bottom,
while the LED and Flex cable connectors are on the top.
Figure 8-2. Connection System Board and DLP LightCrafter Display Board
Figure 8-3
shows the display board and how it connects to the system board. The different connectors for
each LED are named on the board as well as on the light engine.
Always ensure a good connection of the flex cables and LED cables to the DLP LightCrafter Display board
before turning it on.
DMD
Flex Cable
Connector
Red/Green/Blue
LED Connectors
Actuator
Flex Cable
Connector
Figure 8-3. DLP LightCrafter Display EVM
14
EVM Setup
DLPU063 – January 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
Advertisement
Table of Contents
