Table of Contents
Advertisement
This quick-start assumes default conditions as shipped.
1. Power up the DLP LightCrafter™ Display 3310 EVM by applying an external DC power supply (19-V
DC, 3.42 A) to the J4 connector. External Power Supply Requirements:
•
Nominal Output Voltage: 19 VDC
•
Minimum Output Current: 2.5 A; Max Output Current: 3.42 A
•
Efficiency Level: VI
NOTE: TI recommends using an external power supply that complies with applicable regional safety
standards such as UL, CSA, VDE, CCC, and PSE.
NOTE: The P5V_VIN (D1) and P3P3V_SB (D7) LEDs on the System board will turn on to indicate that
5-V power and 3.3-V power are applied.
2. Move SW2 switch to the ON position to turn on the DLP LightCrafter Display 3310 EVM. When the
DLP LightCrafter Display 3310 EVM is turned on, the PROJ_ON LED (D5) will turn on.
3. After the DLP LightCrafter Display 3310 EVM is turned on; the projector will default to displaying a DLP
LightCrafter Display splash image.
4. The focus of the image can be adjusted manually on the optical engine.
5. Connect the USB to the DLP LightCrafter™ Display 3310 EVM and open the latest GUI on your
computer. If needed, connect an HDMI source to the EVM and communicate to the EVM via the GUI
software.
6. When turning off the projector, turn off the SW2 switch prior to removing the power cable.
Note: To avoid potential damage to the DMD, it is recommended to turn off the projector with the SW2
switch before disconnecting the power.
There are fourteen indicator LEDs on the DLP LightCrafter Display 3310 EVM (Display and System
boards), and they are defined in
10
Quick-Start Procedure
Focus
Adjustment
Figure 6-1. Optical Engine with Focus Adjustment
Table
6-1:
Copyright © 2018, Texas Instruments Incorporated
DLPU063 – January 2018
Quick-Start Procedure
DLPU063 – January 2018
Submit Documentation Feedback
Chapter 6
Advertisement
Table of Contents
