www.ti.com
2.3
Selecting the Display Mode
The DLP LightCrafter has four display modes: Static Image/Color, Test Patterns, HDMI Port, and Stored
Pattern Sequence. To upload static 24-bit RGB images or project a single color read section
To use the internally generated test patterns, read
HDMI port read
Section
read
Section
2.8.2. To create a pattern sequence using stored patterns, read
23.
To change the display mode, follow these steps:
1. Click and select the desired display mode from the drop down options as shown in
2. Click the "Set" button as shown in
•
The GUI automatically changes to the correct tab and updates the GUI settings in that tab to
match the EVM's settings if the display mode is properly set.
•
The resolution, active pixels, and active lines are reset to their default value if the display mode
changes from "HDMI Port" to "Stored Pattern Sequence".
•
When the display mode changes, the "Start Vector" and "Num of Vectors" reset to 0.
DLPU006C – January 2012 – Revised December 2013
Submit Documentation Feedback
2.7. To create a pattern sequence using external patterns from the HDMI port,
Figure 2-23. DLP LightCrafter GUI Display Mode Setting
Figure 2-24. DLP LightCrafter GUI Display Mode Options
Figure
Copyright © 2012–2013, Texas Instruments Incorporated
Section
2.10. To stream 24-bit RGB video through the
2-25.
Selecting the Display Mode
Section
Section
2.8.1. See
Figure 2-
Figure
2-24.
Operating the DLP LightCrafter
2.9.
29