Maintenance; Clean And Disinfect - Welch Allyn RetinaVue 100 Imager Directions For Use Manual

Maintenance

Clean and disinfect

The RetinaVue 100 Imager can be cleaned and an intermediate-level of disinfection can
be achieved using the following method.
Cleaning the RetinaVue 100 Imager lens
Wipe the surface of the lens with a cleaning cloth or a lens cleaning tissue such as
Thorlabs Inc.. Avoid touching the lens except when cleaning is required.
Cleaning the RetinaVue 100 Imager
Power off the RetinaVue 100 Imager before cleaning it.
Use a pre-moistened wipe or soft cloth slightly moistened with an approved cleaner to
gently clean the RetinaVue 100 Imager.
Disinfecting the RetinaVue 100 Imager
Use a pre-moistened wipe or soft cloth slightly moistened with an approved disinfectant
to disinfect the RetinaVue 100 Imager. Follow the manufacturers recommendations.
Note
CAUTION Never submerge the RetinaVue 100 Imager in water or any
other liquid.
CAUTION Never use abrasive cleaning agents, thinners or benzene for
cleaning and never immerse the instrument in water or other cleaning
liquids.
CAUTION Never insert a sharp object into the device or any open surface
on the RetinaVue 100 Imager.
CAUTION Do not use unapproved cleaning or disinfection agents. Use of
these agents may cause damage to components.
CAUTION Do not use chemicals other than isopropyl or ethyl alcohol on
the lens.
After cleaning or disinfecting, wait at least 10 minutes before taking
another measurement.
45