Welch Allyn RetinaVue 100 Imager Directions For Use Manual page 33

Directions for use
• Make slight, micro adjustments with your guide hand to fine tune the position of the
RetinaVue 100 Imager. Do not use your hand on the LCD side to make minor
adjustments.
Note
1. Press the power button
Note
Note
2. From the Home screen, touch Exam.
The Preacquistion screen appears.
3. (Optional), If necessary, touch
focus. Touch the up or down arrows in the Advanced image capture settings and
touch OK.
4. Touch Start to enter the Image acquisition mode and begin the first exam of the
patient's right eye (R1).
For additional information about techniques to capture the highest quality
image, see the Technique guide that came with the RetinaVue 100 Imager.
.
To conserve power, the RetinaVue 100 Imager enters stand
by mode and returns to the Home screen if it remains idle
for approximately two minutes. Touch the LCD screen to
wake up the RetinaVue 100 Imager from stand by mode.
After 10 minutes of inactivity in stand by mode, the
RetinaVue 100 Imager powers down. Press the Home
button to activate the RetinaVue 100 Imager.
Using the RetinaVue 100 Imager 29
(Settings) to adjust the illumination, or the