Welch Allyn RetinaVue 100 Imager Directions For Use Manual page 23

Directions for use
4. For first-time setup of the RetinaVue 100 Imager, insert the battery into the battery
compartment. For battery replacement, remove the existing battery and then insert
the new replacement battery into the battery compartment.
a. This procedure applies to first-time setup of the RetinaVue 100 Imager. Insert
b. This procedure only applies to battery replacement. Remove the existing battery
5. Rotate the raised flat edge of the battery until it sets in the back notch of the battery
compartment.
6. Insert the two battery cover tabs into the slot, then push in the tab to close the
battery compartment.
7. Tighten the screw at the left side of the battery cover.
8. Tighten the screw at the right side of the battery cover.
the battery into the battery compartment. Match the polarity of the battery to the
+ and - markings on the RetinaVue 100 Imager.
from the battery compartment and insert the new replacement battery into the
battery compartment. Match the polarity of the battery to the + and - markings
on the RetinaVue 100 Imager.
Using the RetinaVue 100 Imager 19