Welch Allyn RetinaVue 100 Imager Directions For Use Manual page 22

18 Using the RetinaVue 100 Imager
Number
5
6
7
Not shown
Not shown
Not shown
Not shown
If any item is missing, contact Welch Allyn Technical Support:
service. We recommend that you save the shipping box and packing materials in case
you need to store or ship the system.
Battery installation and replacement
Use the device on battery power once the battery is installed and charged. The battery is
charged through contact pins on the device and the docking station.
Install the battery/replace the battery
Set the RetinaVue 100 Imager on a flat, clean surface with the LED display facing down.
1. Loosen the screw at the left side of the battery cover.
2. Loosen the screw at the right side of the battery cover.
3. Push in the battery cover tab and then lift up the battery cover. Slide open the
battery cover by tilting the cover upward.
Item
Eye cup
Battery
Screwdriver
RetinaVue 100 Imager Directions for
use
SD Card
Lens spray
Lens Cloth
WARNING Personal injury risk. Improper handling of the battery can lead
to heat generation, smoke, explosion, or fire. Do not short-circuit, crush,
incinerate, or disassemble the battery. Never dispose of batteries in refuse
containers. Always recycle batteries according to national or local
regulations.
WARNING Use only Welch Allyn approved accessories, and use them
according to the manufacturer's directions for use. Using unapproved
accessories with the camera can affect patient and operator safety and can
compromise product performance and accuracy, and void the product
warranty.
Welch Allyn RetinaVue™ 100 Imager
Description
Blocks ambient light during testing
Rechargeable lithium ion battery
Phillips screwdriver to remove battery cover screws
This document. The Directions for use (DFU) is also available on
the Welch Allyn web site.
SD Card installed in the SD Card slot for data storage
RetinaVue 100 Imager lens cleaner
RetinaVue 100 Imager lens cleaning cloth
www.welchallyn.com/