Silvercrest KH 2377 Operating Instructions Manual page 38

Defect
GB
IE
Function but-
tons are not
functioning
The CD jumps
Failure with
burnt CDs
The radio and/
or the automatic
station saving is
not functioning
Station memory
is not functioning
The device's USB
port does not
function
The card reading
device does not
read the cards
The Bluetooth
connection does
not function
36
Possible cause
There is a malfunction
with the device.
The face plate is not
correctly installed.
The mounting angle exceeds
30°.
The CD is very dirty or
defective.
The antenna cable is not
connected correctly.
The station signals are too
weak.
The connection 4 in the ISO
block A (Permanent positive)
is not connected correctly.
The USB port is intended for
devices that function accord-
ing to the USB standard. Not
all market available devices
conform to this standard. It
is possible that a device is
connected that does not func-
tion according to the USB
standard.
The card is possibly defec-
tive, dirty or not properly
inserted.
The mobile phone does not
support Bluetooth transmis-
sions.
The mobile phone is not
coupled with the device.
NOTICE
► If you cannot solve the problem with the aforementioned methods, please
contact Customer Service.
Troubleshooting
Solution
Press the RESET button.
Check to see that the face plate is
installed correctly.
Correct the mounting angle.
Clean the CD or insert a diff erent CD.
Check the burnt CD in another
playback device.
Check the antenna cable for correct
connection.
Set the station manually.
Check the cable connections. For this
consult the chapter "Connections".
Connect a device that functions accord-
ing to the USB standard. Make sure
that the data carrier is formatted for the
FAT32 fi le system.
Check the card. Slide it in with the
inscribed side facing to the right. Make
sure that the data carrier has been
formatted to the FAT32 fi le system.
Reconnect the mobile phone and the
device. For this also read, without fail,
your mobile phone's instructions.
KH 2377