Table 5-3. Remote Tcp Setup - Sierra Wireless DART 200 CDPD Modem User Manual

DART 200 CDPD Modem User's Guide
Sierra Wireless, Inc.

Table 5-3. Remote TCP setup

AT Command
AT^Annn.nnn.nnn.nn
n
AT\N[1,2]
AT\J0
AT\R4
ATS13=0
AT\O0
AT*A1
ATS0 =1
AT*L2100
ATE0
ATV0
ATQ0
ATF1
ATX1
AT&C1
AT&D0
AT&E2
AT&S0
AT\F3
AT\M0
AT\Q0
AT\T1
AT*B0
AT*C1
AT*G1
AT*K2
ATS86 = 3
AT*R0
AT*T0
Req Opt Def Description
Input IP Address (if not already
R
done)
Side Preference (get from carrier)
R
D Use default - No channel access
restrictions
R Auto Registration at Power On
With AT\R4 sets Continuous
R
Automatic Registration
R PAD mode is required for TCP
Sets TCP Server mode
R
O Set modem to Auto Answer
D Use default - Listen on port 2100
O No command mode character echo
Use terse result codes
O
D Use default - Result codes are sent to
the RTU
D Use default - Do not echo
transmitted data to the RTU
D Use default - Extended result codes
D Use default - DCD follows state of
the connection
D Use default - You may want to
consider using DTR to escape if
RTU supports it
Filter escape sequence from output
O
D Use default - DSR is always active
D Use default - Applies only if \M1
specified
D Use default - Do not recognize data
forwarding characters
Most RTUs do not use flow control
O
D Use default - Timed data forwarding
should always be used with binary
data
D Use default - Does not apply to TCP
D Use default - Does not apply to TCP
D Use default - Does not apply to TCP
O Set TCP receive keep-alives
Use 3 minute keep-alive timeout
O
D Use default - Does not apply to TCP
D Use default - Does not apply to TCP
5 DART Supported Protocols
5-20