Table 5-2. Host Udp Setup - Sierra Wireless DART 200 CDPD Modem User Manual

DART 200 CDPD Modem User's Guide
PN1197-00 Revision 1.0

Table 5-2. Host UDP setup

AT Command
AT^Annn.nnn.nnn.nnn
AT\N[1,2]
AT\J0
AT\R4
ATS13=0
AT\O0
AT*A0
AT*L2100
ATS82=0
ATE0
ATV0
ATQ0
ATF1
ATX1
AT&C1
AT&D0
AT&E2
AT&S0
AT\F3
AT\M0
AT\Q2
AT\T1
AT*B0
AT*C1
AT*G1
AT*K0
AT*R0
AT*T0
Req Opt Def Description
Input IP Address (if not already done)
R
R Side Preference - (get from carrier)
D Use default - No channel access
restrictions
R Auto Registration at Power On
With AT\R4 sets Continuous
R
Automatic Registration
PAD mode required for UDP.
R
D Use default - No server function
required
D Use default - Listen on port 2100
Turn off backward compatibility.
R
No command mode character echo
O
O Use terse result codes
D Use default - Result codes are sent to
the host
D Use default - Do not echo transmitted
data to the host
D Use default - Extended result codes
D Use default - DCD follows state of
the connection
D Use default - You may want to
consider using DTR to escape
Filter escape sequence from output
O
D Use default - DSR is always active
D Use default - Applies only if \M1
specified
D Use default - Do not recognize data
forwarding characters
D Use default - Most PC's use flow
control
D Timed data forwarding - Always use
with binary data
D Use default - Many CDPD Carriers
have not implemented Broadcast.
D Use default - Does not apply to UDP
D Use default - Does not apply to UDP
D Use default - Does not apply to UDP
D Use default - Does not apply to UDP
D Use default - Does not apply to UDP
5 DART Supported Protocols
5-13