Table F-7 Service Provider Commands Beginning With Dash - Sierra Wireless DART 200 CDPD Modem User Manual

DART 200 CDPD Modem User's Guide

Table F-7 Service Provider commands beginning with dash (-)

-L Lock on a Specific Channel
Permits the DART to override normal Radio Resource Management functions and lock itself on a
specific channel.
This is useful at Trade Shows where exhibitors are often requested to operate on a specific channel. It is
also helpful during initial testing when it sometimes is necessary to seek out a specific channel.
The modem continues to operate on the assigned channel until the lock is removed, changed to another
channel, or bit 2 in S-Register 60 is turned off.
Format:
AT-L<n>
AT-L-
Result codes:
OK
ERROR
NOT ENABLED
-R Software Reboot of the DART
Reboots (restarts) the DART. It is equivalent to power cycling the modem. Use this command to
activate changes in the modems operating parameters such as \J, \N, *A, *L, IP Address, and CDPD
operating mode (SReg95).
Format:
AT-R
Result codes:
NOT ENABLED
-V View Radio Resource Management Data
Displays the current value of pertinent Radio Resource Management Data. Some of this data are the
Carrier operating (XID) parameters to be used by the modem; other data is statistical accumulations of
channel acquisition and channel hopping data that is accumulated between modem resets.
NOTE:
To avoid clearing the accumulated statistical data you must not reset the modem.
Format:
AT-V2
AT-V3
AT-V4
AT-V5
Result codes:
ERROR
NOT ENABLED
Sierra Wireless, Inc.
Locks the modem on channel <n>
Releases the channel lock
Valid argument
Invalid argument
Modem is not in service provider mode
Reboot (restart) the DART
Modem is not in service provider mode
View channel stream, quality, and access parameters
View Adjacent Cell Configuration Information
View channel acquisition statistics
View channel hopping statistics
Invalid Argument
Modem is not in service provider mode
F DART AT Command Set
F-30