Soft Reset - Sierra Wireless DART 200 CDPD Modem User Manual

DART 200 CDPD Modem User's Guide
Table F-1. Commands beginning with letters (cont.)
X Extended Result Codes
Selects whether the DART enables extended result codes. By default all result codes are enabled.
Format:
ATX0
ATX1
Result codes:
OK
ERROR
Z

Soft Reset

Performs a soft reset on the DART, aborting any active connection, and resets all modem profile
parameters to their saved values. The network registration status is not affected.
Format:
ATZ
Result code:
OK
? Read Selected Register
Returns the value of the register selected by the S command.
Format:
AT?
ATSn?
ATS?
Result codes:
A numerical value, decimal or hexadecimal (denoted by a leading 0x), representing the contents of
the specified S-Register.
ERROR
= Write Selected Register
Alters the value in the currently selected S-Register. The format of the parameter is numeric or text,
depending on the particular register being modified. Numeric values are specified in decimal. If the
S register contains text then this command must be last on the command line.
Format:
ATSn=x
AT=x
Result codes:
OK
ERROR
NOT ENABLED
Sierra Wireless, Inc.
Enable only codes 0...4 Extended results are mapped as appropriate to code 0...4
Enable all extended result codes (default)
Valid argument
Invalid argument
Perform soft reset
Command complete
Read value of most recently selected register
Read value of register <n>
Read value of register 0
Invalid register number
Set register <n> to <x>
Sets selected register (last one referenced explicitly) to <x>
Valid parameter value
Invalid value for selected register, or register is read only (RO)
Must be in Service Provider mode to alter this register
F DART AT Command Set
F-8