Sierra Wireless AirCard 555 User Manual page 32

AirCard 555 Network Card User Guide
32
Installing the Modem Driver
1. In the Control Panel, double click the Modem icon to open
the Modem Properties window.
Add
2. Click the button to open the Install New Modem
wizard.
Don't detect my modem, I will select it from a list
3. Select
Next
.
Have Disk
4. Select the
d:\Drivers\WinNT\mdmac555
Enter
5.
for your CD-ROM drive and click
OK
6. Click .
Sierra Wireless AirCard 555 Modem
7. Verify that
Next
and click .
Selected Ports
8. Select the
communications port you selected when you installed the
network card driver. Click
Finish
9. Click .
10. If you are prompted that Dial-Up Networking needs to be
Yes
configured, click
Add
11. Click in the Remote Access Setup window.
12. Select the AirCard 555 listing under RAS Capable Devices
OK
and click .
13. If you are prompted to restart your PC, click
Otherwise restart your PC from the Start menu.
14. When the PC restarts, re-install your Service Pack.
On completion of this step, the modem driver is installed.
Verify that Remote Access Service is installed before
proceeding to install the Venturi software.
Verifying that RAS is Installed:
1. In the Control Panel, double click the
the Network window.
Services
2. Click the tab.
Remote Access Service
3. If
the component is installed and you can skip to the next
section. Otherwise, proceed to step 4.
Computer Browser
4. Click to select
Add...
5. Click the button to open the Select Network Service.
Remote Access Service
6. Select
7. If the Windows NT Setup window appears, either insert
the Windows NT CD and enter your CD-ROM drive letter,
or enter the path to the .CAB files. Click
button.
d
where is the drive letter
Open
.
radio button and select the same
Next
.
.
Network
is listed under Network Services,
.
OK
and click .
Continue
and click
is displayed
Yes
.
icon to open
.
2130142