Sierra Wireless AirCard 555 User Manual page 30

AirCard 555 Network Card User Guide
Note: Use the Windows NT
Diagnostics window to locate an
available IRQ and I/O space.
Make note of the Com Port that
you use to install the network
card driver. You must enter the
same Com Port when installing
the modem driver.
30
Installing the Network Card Driver When Networking Has
Not Been Installed:
Yes
1. Click at the prompt, "Do you want to install it now?"
to launch the wizard that installs Networking.
2. Click the check boxes on the first window of the wizard so
Wired to the network:
that
network:
is NOT checked. Click
Select from list...
3. Click the
Network Adapter window.
Have Disk...
4. Click the
window.
5. If you have copied the driver from the AirCard installation
CD to your hard drive, enter the path to the driver and
OK
click to open the Select OEM Option window.
6. If you are installing the driver from the AirCard instal-
d:\Drivers\WinNT
lation CD, enter
for your CD-ROM drive and click
OEM Option window.
7. If Sierra Wireless AirCard 555 is highlighted, click
Sierra Wireless AirCard 555 should appear in the Network
Setup Wizard under Network Adapters. Otherwise click
Cancel
and repeat the previous two steps.
Next
8. Click to display a list of network protocols.
TCP/IP Protocol
9. Ensure
protocols appropriate to your network configuration) and
Next
click to display a list of network services.
10. Select the services appropriate to your network configu-
Next
ration and click
AirCard 555, it does not matter what selections you make
in this window.)
Next
11. Click .
12. If the Windows NT Setup window appears, system files
are required to install the components you checked. Either
insert the Windows NT CD and enter your CD-ROM drive
letter, or enter the path to the .CAB files. Click
13. Use the drop down menus to select an I/O Port, Interrupt,
Memory, and Com Port, noting that the AirCard 555
requires 1 IRQ and 40 bytes of I/O Space. Click
14. If the Windows NT Setup window appears again, enter the
path to your CD-ROM drive or the CAB files.
Yes
Click at the DHCP prompt to proceed to a display of
15.
network bindings. (DHCP or Dynamic Host Configuration
Protocol is required by the AirCard 555 regardless of your
network configuration.)
Remote access to the
is checked and
Next
to proceed.
button to open the Select
button to open the Insert Disk
d
where is the drive letter
OK
to open the Select
is checked (as well as any other
. (For the purpose of installing the
OK
. The
Continue
.
Continue
.
2130142