Sierra Wireless AirCard 555 User Manual page 28

AirCard 555 Network Card User Guide
Note: Do not forcefully connect
the antenna, or forcefully insert
the AirCard. This may damage
connector pins. See page 34 for
instructions on removing the
AirCard.
28
Windows XP Driver Installation
1. Attach the antenna to the AirCard and, with the label
facing up, carefully insert the AirCard into your PC Card
slot. Windows should detect that a new device has been
inserted and launch the wizard that guides you through
the driver installation.
Install from a list or specific location (Advanced)
2. Select
first window of the Found New Hardware Wizard and
Next
click to proceed.
Search for the best driver in these locations
3. Select the
Include this location in the search
button, and the
d:\Drivers\WinXP
then enter
your CD-ROM drive. Click
window.
4. If a warning appears stating that AirCard 555 has not
passed Windows Logo testing, click
Finish
5. Click and repeat steps 1 to 4 as prompted.
OK
6. Click when prompted that the AirCard 555 has been
successfully installed.
On completion of this step, the driver is installed and you can
proceed to install the Venturi software. This is described in the
"Venturi Software Installation" section on page 33.
Windows NT Driver Installation
Since Windows NT does not have the "Plug and Play" feature
included in other Windows operating systems, installing the
AirCard driver requires more steps. Installation involves:
• Verifying that your PC Card slots are enabled
• Checking whether Networking is installed
• Installing the network card driver (procedures depend on
whether or not Networking is already installed)
• Installing the modem driver
• Verifying that RAS (Remote Access Service) is installed
Note: You must re-install the Windows NT Service Pack after you
install the AirCard driver. Ensure you have your Service Pack CD
before you begin. (Version 6a is supported.)
on the
radio
check box,
d
where is the drive letter of
Next
to proceed to the next
Continue Anyway
2130142
.