Siemens 300Series User Manual page 85

To clear a
repdial key on a
display
telephone
Note: You cannot clear a repdial key on a non-display telephone or
any telephone without a Clear key, though you can set it up to
dial a different sequence.
To dial using a
repdial key
Press the Program key. The Program status
light turns on. PRESS FEATURE KEY OR
DIAL CODE is displayed.
Press the repdial (R-) key you want to
clear. REPDIAL is displayed, followed by
the dialing sequence.
Before NEW NUMBER? is displayed,
press the Clear key. DELETED is then
displayed.
To clear another R- key, press the Store
key. STORED is displayed. Repeat the two
previous steps.
To end setup, press the Program key. The
Program status light turns off.
On your faceplate, erase the label next to
each R- key you have cleared.
Press the repdial (R-) key.
Making Calls 3-27