Control Modes (P1300); Faults And Warnings - Siemens MICROMASTER 411 Operating Instructions Manual

Issue 03/01
4.4

Control Modes (P1300)

The various modes of operation of the MICROMASTER 411 control the relation-
ship between the speed of the motor and the voltage supplied by the inverter. A
summary of the control modes available are listed below:
Linear V/f control
Can be used for variable and constant torque applications, such as conveyors
and positive displacement pumps.
Linear V/f control with FCC (Flux Current Control)
This control mode can be used to improve the efficiency and dynamic
response of the motor.
Quadratic V/f control
This mode can be used for variable torque loads, such as fans and pumps.
Multi-point V/f control
Multi-point V/f allows the user to define their own V/f Characteristics.
This characteristic uses two fixed coordinates and three pairs of variable
coordinates.
Fixed co-ordinates are:
Variable co-ordinates may be obtained from the following three pairs of
coordinates
P1320 (frequency) -P1321 (voltage)
P1322 (frequency) -P1323 (voltage)
P1324 (frequency) -P1325 (voltage)
User programmable V/f characteristics are often used to provide correct torque
at correct frequency, which can be useful when using the Inverter with
synchronous motors. See Parameter List for further detail.
4.5

Faults and warnings

LED Fault Indication
Fault states and warnings are indicated by the LED within the control potentiometer
on the inverter, see section 6.1 for further information.
BOP fitted
If a BOP is fitted, the fault states (P0947) and warnings (P2110) are displayed
should a fault condition occur. For further details, please refer to section 6.2.
AOP fitted
If the AOP is fitted, fault and warning codes are displayed on the LCD panel.
MICROMASTER 411 & COMBIMASTER 411
6SE6400-5CA00-0BP0
4 Using the MICROMASTER 411 / COMBIMASTER 411
Boost as defined in P1310 at 0 Hz.
Nominal voltage P0304 at nominal frequency P0310
Operating Instructions
P1300 = 0
P1300 = 1
P1300 = 2
P1300 = 3
65