Table 3-3 Control Circuit Jumper Settings; Table 3-4 Control Circuit Jumper Behaviour; Figure 3-4 Control Circuit Jumpers - Siemens MICROMASTER 411 Operating Instructions Manual

3 Commissioning
Figure 3-4 Control Circuit Jumpers
Table 3-3 Control Circuit Jumper Settings
Jumper Jumper Fitted
Pot = Run P0700 = 2
P0705 = 1 (motor potentiometer)
P1210 = 6 automatic restart
24 AIN No software effect
DC Brake Uses the jumper settings for the ramp settings by the
duration of the direct current braking, to be calculated as
follows.
Duration of direct current braking =
P1121 (deceleration time) *
If the drive is quicker to come to a standstill because of the
load conditions, the direct current braking still remains
active fo the calculated time time.
Otherwise the value is held in P1233 (duration of the diret
current braking)
Fan/Pump: M~n2 P1300 = 2 (fan curve/quadratic vf)
50/60 Hz Rated Motor Frequency = 60 Hz
Control Jumpers
In Table 3-4 the behaviour of the Control Jumpers are explained.
Table 3-4 Control Circuit Jumper Behaviour
Status before action(s) Action(s)
Jumper not fitted
Jumper fitted
Jumper fitted
Jumper not fitted
48
P0305 (nominal motor current)
r0207 (nominal inverter current)
Reaction(s) of the inverter
Power down Parameters influenced by jumper will have jumper default
values
Fit jumper(s)
Power up
Cycle power Parameters influenced by jumper are not changed
Power down Parameters influenced by jumper will have "jumper
removed" default values (normally factory default)
Remove jumper
Power up
Cycle power Parameters influenced by jumper are not changed
MICROMASTER 411 & COMBIMASTER 411
Issue 03/01
Jumper Removed
P0700 = 2
P0701 = 1
P1210 = 1
No software effect
P1233 = 0
P1300 = 0 (linear vf)
Rated Motor Frequency = 50 Hz
Operating Instructions
6SE6400-5CA00-0BP0