Remote Control, Protocol Setup - Barco Bragi User Manual

Getting to know the projector.
Tip: Use alkaline batteries for optimum range and life time.
Image 2–2
3. Insert (1) both lower tabs of the battery cover in the gaps at the bottom of the remote control, and press (2)
the cover until it clicks in place.
Image 2–3
When replacing batteries, the broadcast address of the RCU will be reset to its default value '0'.
CAUTION: Replace with the correct battery type. Use two AA size batteries

2.8.2 Remote control, protocol setup

About the used protocol
The protocol is the code send out by the remote control when a button is pressed. Depending on this code, the
projector can decode the signals. The remote control can be used with two different protocols, RC5 and NEC.
Depending on the projector to control, the remote control can be switched between these protocols.
Which protocol to use
• The NEC protocol have to be used for Barco projectors based on the Pulse platform: Loki, Balder, F40.
F70, F80, F90, HDX 4K, UDX, UDM and more..
• The RC5 protocol have to be use all other Barco projectors: HDX W, HDF W, HDQ 2K, ...
How to set
1. Remove the cover. For more info on how to remove, see
2. Place the switch in the NEC position.
24 R5911698 /07 Bragi
2
1
"Remote control, battery installation", page 23.