Mounting The Output Elements; Figure 5-1 Balancing Type On The Drive-End Side - Siemens 1PH818 Operating Instructions & Installation Instructions

5.2.4

Mounting the output elements

Balance quality
The rotor is dynamically balanced. For shaft extensions with featherkeys, the balancing type
is specified using the following coding on the face of the drive end of the shaft:
● "H" means balancing with a half feather key
● "F" means balancing with a whole feather key.
Pushing on the power output elements
● Prerequisites:
● Pulling on:
SIMOTICS M-1PH8 1PH818., 1PH822.
Operating Instructions 07/2016
Figure 5-1 Balancing type on the drive-end side
– The coupling and/or the output element must be appropriately dimensioned for the
operating case at hand.
– Comply with the coupling manufacturer's instructions.
– Make sure that the balancing type of the transmission element correctly matches the
type of balance of the rotor.
– Use only ready drilled and balanced transmission elements. Check the hole diameters
and the balancing status before pulling them on. Thoroughly clean the shaft extension.
– Warm up the transmission elements to expand them before pulling them on. Select the
temperature difference for the heating process to suit the coupling diameter, fit and
material. See the coupling manufacturer's instructions.
– Power output elements may only be pushed on or pulled off with the correct equipment.
The transmission element must be pulled on in one continuous operation via the front
thread holes in the shaft or pushed on by hand.
– Do not strike it with a hammer, as this would damage the bearings.
5.2 Lift the machine to where it will be mounted and position it
Mounting
55