Transport And Storage; Checking The Delivery; Lifting And Transportation - Siemens 1PH818 Operating Instructions & Installation Instructions

Preparations for use

4.13 Transport and storage

4.13 Transport and storage
When carrying out any work on the machine, observe the general safety instructions
(Page 13) and the specifications contained in EN 50110‑1 regarding safe operation of electrical
equipment.
4.13.1

Checking the delivery

Checking the delivery for completeness
The drive systems are put together on an individual basis. When you take receipt of the
delivery, please check immediately whether the items delivered are in accordance with the
accompanying documents. Siemens will not accept any claims relating to items missing from
the delivery and which are submitted at a later date.
● Report any apparent transport damage to the delivery agent immediately. Never
● Report any apparent defects/missing components to the appropriate Siemens office
These safety instructions are part of the scope of supply; keep them in a location where they
can be easily accessed.
4.13.2

Lifting and transportation

To safely lift and transport the machine, the following requirements must be met:
● Personnel operating cranes and fork-lift trucks must be appropriately qualified.
● If the motor is packed, depending on the weight, size and on-site conditions, lift crates and
● When lifting the machine, use only approved and undamaged sling guides and spreaders
● When lifting the machine, refer to the information on the lifting plate.
● Use only the load carrying device on the stator frame for lifting.
36
commission a damaged motor.
immediately.
transport frames using a fork-lift truck or a crane with slings. Use a crane or fork-lift truck
suitable for the load.
of sufficient rated capacity. Check the lifting equipment prior to its use. The weight of the
machine is shown on the rating plate.
– Comply with the specified spreading angles.
– Do not exceed the maximum lifting acceleration and lifting speed specified on the lifting
plate. Lift the machine without jerking it.
Acceleration a ≤ 0.4 g (≈ 4 m/s
Velocity v ≤ 20 m/min
)
2
SIMOTICS M-1PH8 1PH818., 1PH822.
Operating Instructions 07/2016