Replacing The Drive-Cliq Interface (Encoder Module); Figure 9-4 Electrical Connection Of The Speed Sensor - Siemens 1PH818 Operating Instructions & Installation Instructions

1. Insert the connector into the socket.
2. Press the cable into the holder provided for it.
3. Screw on the sensor cover. Take care that you do not catch the cable as you screw it in.
Note
Replacing or adjusting the speed encoder
Replacing or adjusting the speed encoder in an incorrect manner can result in machine
malfunctions. Arrange to have the speed encoder replaced or adjusted by Siemens service
personnel. This will ensure problem-free functioning.
9.3.5

Replacing the DRIVE-CLiQ interface (encoder module)

Only trained Siemens service engineers (Page 131) are authorized to replace the DRIVE-CLiQ
interface (sensor module).
NOTICE
Electrostatic discharge
Electronic modules contain components that can be destroyed by electrostatic discharge.
These modules can be easily destroyed by improper handling.
To protect your equipment against damage, follow the instructions given in the chapter ESD
Guidelines (Page 18).
SIMOTICS M-1PH8 1PH818., 1PH822.
Operating Instructions 07/2016
Figure 9-4 Electrical connection of the speed sensor
Maintenance
9.3 Repair
117