Holding Brake; Ordering Spare Parts Via The Internet; Anti-Condensation Heating - Siemens 1PH818 Operating Instructions & Installation Instructions

Spare parts

10.5 Anti-condensation heating

Note
DRIVE-CLiQ interface
If you order a DRIVE-CLiQ interface, please specify when ordering from Spares on Web that
the DRIVE-CLiQ interface must be described along with the motor data.
If roller-contact bearings with an insulated design are installed, use roller bearings of the same
type as spare parts. This will prevent any bearing damage being caused by bearing currents.
10.3

Holding brake

Contact your Service Center for spare parts for the holding brake.
See also
Operating instructions, holding brake (Page 139)
10.4

Ordering spare parts via the Internet

Spare parts can be ordered online from the spare parts service "Spares on Web":
Spares on Web (https://b2b-extern.automation.siemens.com/spares_on_web).
You can use "Spares on Web" to determine the order numbers for motor spare parts quickly
and easily.
A short description of how to use "Spares on Web" is available on the Internet.
Guide for Spares on Web (http://support.automation.siemens.com/WW/news/en/25248626).
10.5 Anti-condensation heating
The anti-condensation heater is mounted directly on the winding. The anti-condensation heater
cannot be removed without causing damage to the winding. A new anti-condensation heater
may only be installed by Siemens Service Center (Page 131) specialists.
120
SIMOTICS M-1PH8 1PH818., 1PH822.
Operating Instructions 07/2016